How to configure both water wheels in DREADMOOR (2026 video game)
Last checked: · Public sources listed below
The job is not “fix one wheel.” The gate stays shut until the left wheel and the right wheel are both turning and stay turning. Guides from dread-moor.wiki, dreadmoors.wiki, and dreadmoor.site describe the same order: generator power, Thermal Coil, two Buckets, the pump repaired in place, then the water routing, then Gate Control.
The flow controls split a single feed. Open the dry side, then look back at the side you just left. Players stall here by feeding one wheel and pinching the other. A center balance set near even is the setting those guides describe. I am not copying PSI numbers or a “procedural variant” from a fourth site, because no second source repeats those figures.
A green lamp on the console means the valve is open. It does not mean the wheel has water. Watch the wheel. If the journal still says “repair machinery,” a part is missing, usually the second bucket or the pump. If it says “configure water flow,” leave the generator alone and work the split. If both wheels turn and the door stays shut, go back to Gate Control and pull it. The first pull was supposed to fail.
Update #2 also stopped Throat props falling through the floor and fixed a soft lock on the generator when an item was in hand. If a wheel housing looks empty after a reload, that patch is the first thing to confirm you are on, before you rebuild parts.
Repair dependency diagram from the two walkthroughs in Sources. This shows dependencies rather than distances or pressure settings.
- Thermal Coil + Gear
- Two Buckets + Pump repair
- Check each water-wheel side
- Try the gate control again
| Journal line | What is actually wrong | What to touch |
|---|---|---|
| Repair machinery | A part is still out | Thermal Coil, Gear, both Buckets, pump in place |
| Configure water flow | The split is uneven | Feed the dry wheel, then recheck the other |
| Both wheels turn, gate shut | Control was not pulled again | Gate Control, after the first failed pull |
| Green lamp, wheel still | Valve open, volume short | Balance the feed; ignore the lamp |
Next steps
Questions
One wheel spins. Why is the gate shut?
The lock wants both wheels at once. A single spinning side is the common miss.
Should I craft a replacement pump?
The walkthroughs say to repair the pump where it is. A lathe copy is the workaround they tell you to skip.
Sources
- dread-moor.wiki — The Throat Guide — checked 2026-11-11
- dreadmoors.wiki — The Throat gate puzzle — checked 2026-11-11
- Steam — Early Access Update #2 — checked 2026-11-11